Exclusive motion detector for the UFO Smart LED Bell SHARK.

Installation is very simple thanks to the connection pins that fit perfectly into the base of the UFO Smart LED Bell. Once the pins have been inserted, it is only necessary to turn it a little so that it is completely installed.

The motion detector works with the remote control sold separately.

Our motion sensor that dims the lighting from higher to lower depending on movement.
This slim, low-profile sensor is designed to be installed inside the lower body of a light fixture, UFO High Bay.

The sensors use microwave detection technology that reacts to changes in motion within the coverage area.

Once the sensor stops detecting motion and the delay time elapses, the lights will switch from high mode to low mode and eventually to the OFF position if desired.

Sensors must directly "see" the movement of a person or object in motion in order to
detect them, so special attention must be paid to the location of the sensor luminaire and the selection of the lens.

Avoid placing the sensor where obstructions may block the sensor's line of sight.

NOTE 1: Warm-up time is 15 seconds. After the sensor connects the input power for the first time, the light will stay on for 15 seconds and then dim to operate normally.

NOTE 2: Factory default setting: 100% sensitivity, timeout: 5 minutes, daylight sensor is (Sun Symbol), dimming level: 30%, fade time: 60 minutes.

NOTE 3: Any settings changed by remote control, the LED light connecting the sensor will turn on/off as confirmed.

This product has a 5 year warranty

TECHNICAL DATA SHEET