Exclusive motion detector for the UFO DIAMOND LED Bell 

Installation is very simple thanks to the connection pins that fit perfectly into the base of the DIAMOND LED Bell. Once the pins are in place, just twist a little to install it completely.

The motion detector works with the remote control sold separately.

Our motion sensor that dims the lighting from higher to lower depending on movement.
This sensor is designed to be installed inside the lower part of the body of a light fixture, UFO High Bay.

The sensors use microwave detection technology that reacts to changes in motion within the coverage area.

Once the sensor stops detecting motion and the delay time elapses, the lights will switch from high mode to low mode and eventually to the OFF position if desired.

Sensors must directly "see" the motion of a moving person or object in order to detect them, so special attention must be paid to the location of the sensor luminaire and the selection of the lens.

Avoid placing the sensor where obstructions may block the sensor's line of sight.

TECHNICAL DATA SHEET